Hello Guys, I am new the forums ad well as a novice programmer/troubleshooter.
My software is Siemens S-7 for a 300 PLC.
My problem: Coding, I have a program (1-6) that goes through number of cycles when the cycles are done. The counter compares in a fashion of Count(>=)number of cycle. Then when is met should reset, then move onto the next program 2 and so forth.
The counter is in the MW110 integer and being compared via integers. While in the rotation one the cycle number is reach. instead of resetting the MW110 climbs several more values.
the fashion of how I am resetting is moving zero into the location of MW110.
I am confused to where to look for the solution. I was hoping I could gain some insight from any of you.
My software is Siemens S-7 for a 300 PLC.
My problem: Coding, I have a program (1-6) that goes through number of cycles when the cycles are done. The counter compares in a fashion of Count(>=)number of cycle. Then when is met should reset, then move onto the next program 2 and so forth.
The counter is in the MW110 integer and being compared via integers. While in the rotation one the cycle number is reach. instead of resetting the MW110 climbs several more values.
the fashion of how I am resetting is moving zero into the location of MW110.
I am confused to where to look for the solution. I was hoping I could gain some insight from any of you.