I tried searching. I even called tech but I can't seem to figure this out. I am using a scanner to prevent someone walking under a carriage that moves vertically. When the carriage reaches the floor to load and unload I need to mute the scanner. Had that all fine and dandy until cycling power on the machine. The scanner doesn't come back in a muted state, Keyence has confirmed they wont ever. So how to get back to a muted state after bootup? Tech says I need the Mute sensor, override signal and reset signals in that order to remute. I haven't been any kind of successful with this.
Not sure if I'm just in the weeds or if something else is wrong. Attached is what I'm using to trigger mute and what I thought should work to initiate override.
Thanks!
Not sure if I'm just in the weeds or if something else is wrong. Attached is what I'm using to trigger mute and what I thought should work to initiate override.
Thanks!