Steve Ackerman
Member
- Join Date
- Jun 2003
- Posts
- 16
First, is there a method of displaying a Koyo program directly on this message. I made a bitmap but it was over the 75Kb limit. I was able to make a .fax file but couldn't do anything else with that extension. I would prefer to display it direct so you wouldn't have to have Automation Direct software to view the program. This is why I zipped it up. It would be nice if I could select all the rungs and do a CTRL C and then paste them to a JPEG file. (one rung per .bmp doesn't seem the good way to do it.)
Looking for feed-back on this program. It is an analog program that works but the resolution is not good enough. With a window of 10 micron measurement, there can be no imperfect values after a measurement is taken. This program analog proved to be off by as much as a micron. There is no adjustment of the analog voltage with a Koyo DL240. I don't want to put in any fudge factors in the program to get good values.
It looks like serial data from the electronic micrometer to the Koyo is a pain if it can be done at all. I am going to use a Keyence plc now which serial(RS232)will be used.
Looking for feed-back on this program. It is an analog program that works but the resolution is not good enough. With a window of 10 micron measurement, there can be no imperfect values after a measurement is taken. This program analog proved to be off by as much as a micron. There is no adjustment of the analog voltage with a Koyo DL240. I don't want to put in any fudge factors in the program to get good values.
It looks like serial data from the electronic micrometer to the Koyo is a pain if it can be done at all. I am going to use a Keyence plc now which serial(RS232)will be used.