TEOWK
Member
I have a new project that applies 4 load cell to a single weighing indicator. The load is a cement powdwer buffer hopper. Total load is 30 ton including the hopper.
1) Is there any special requirement for the cable that connect these 4 load cell to Mettler Toledo Indicator, as the distance from the load cell to weighing indicator will be about 150m.
2) I am told to use a OMRON PLC. This project require a sum of four weighing indicator, each connect to 4 load cell. I planned to use an RS485 with protocol macro to obtain the weight data. Does Mettler Toledo support OMRON protocol in this case?
1) Is there any special requirement for the cable that connect these 4 load cell to Mettler Toledo Indicator, as the distance from the load cell to weighing indicator will be about 150m.
2) I am told to use a OMRON PLC. This project require a sum of four weighing indicator, each connect to 4 load cell. I planned to use an RS485 with protocol macro to obtain the weight data. Does Mettler Toledo support OMRON protocol in this case?