Hey everyone,
I am new to using the LogicMaster 90-30 software for the GE Fanuc 90-30 PLC, and I needed some help in incrementing registers. Specifically, I have a move function where I put in an analog signal and sample it at 10 ms intervals. I want to store each sample by assigning a register to each. However, I want to be able to increment the register reference address every 10 ms so that the data does not get overwritten. So, say I have 8 samples over a span of 80 ms, and I store the first sample to reference address R101. I want to know how to increment R101 to R102, R103..etc while sampling so that I do not overwrite the sample I stored in R101. I know there is a Up Counter but it is outside the function itself. Does anyone have a suggestion that could help me? Thanks. Look forward to replies.
I am new to using the LogicMaster 90-30 software for the GE Fanuc 90-30 PLC, and I needed some help in incrementing registers. Specifically, I have a move function where I put in an analog signal and sample it at 10 ms intervals. I want to store each sample by assigning a register to each. However, I want to be able to increment the register reference address every 10 ms so that the data does not get overwritten. So, say I have 8 samples over a span of 80 ms, and I store the first sample to reference address R101. I want to know how to increment R101 to R102, R103..etc while sampling so that I do not overwrite the sample I stored in R101. I know there is a Up Counter but it is outside the function itself. Does anyone have a suggestion that could help me? Thanks. Look forward to replies.