Hi all
I'm attempting to use a Phoenix Contact signal conditioner - the device accepts mV signals and converts this to a 4-20mA output.
The device is meant to be 'loop powered', only when I connect it to a Wago 750-455 analog input card (4-20mA input module) the device is unresponsive.
I'm a bit new to all of this. Is this a limitation of the AI card?
I've connected the signal conditioner to my Fluke 789 4-20mA source output and it powers up the signal conditioner perfectly.
Am I doing something wrong, or is my AI card just incapable of powering the device?
I'm attempting to use a Phoenix Contact signal conditioner - the device accepts mV signals and converts this to a 4-20mA output.
The device is meant to be 'loop powered', only when I connect it to a Wago 750-455 analog input card (4-20mA input module) the device is unresponsive.
I'm a bit new to all of this. Is this a limitation of the AI card?
I've connected the signal conditioner to my Fluke 789 4-20mA source output and it powers up the signal conditioner perfectly.
Am I doing something wrong, or is my AI card just incapable of powering the device?