phuz
Member
I re-did a machine for a customer, which had Yaskawa MP2300Siec w/ 5-axis and Phoenix Contact Ethernet/IP I/O. According to the drawing and the PLC program, the bus coupler was 192.168.1.10. While the machine was being refurb'd, it sat powered off for about a month. I am now trying to set it up to communicate with Allen Bradley hardware, but I can't even ping the bus coupler. I wouldn't think that this would lose its memory after a month. I did load BOOTP but didn't see the bus coupler on there, so I don't believe it to have reverted to factory settings. I am afraid to perform a reset on it because I don't know what settings are stored in there.
This is my first time using Phoenix I/O. Any help appreciated.
This is my first time using Phoenix I/O. Any help appreciated.