ETSM
Member
Hi all - this is my first post so here go's...
I've got a problem with a MAC 40 HMI panel, it's connected to a FX PLC but whenever it powers up it always starts in the Programming mode.
I can get it to show Setup for a few seconds, but before I can do anything to it the screen changes to say there is a communication error.
I've downloaded the manual for it but it doesn't say how I can get it to stay in the Setup mode to check / amend the communication / other parameters.
Any help would be appreciated.
Dave
I've got a problem with a MAC 40 HMI panel, it's connected to a FX PLC but whenever it powers up it always starts in the Programming mode.
I can get it to show Setup for a few seconds, but before I can do anything to it the screen changes to say there is a communication error.
I've downloaded the manual for it but it doesn't say how I can get it to stay in the Setup mode to check / amend the communication / other parameters.
Any help would be appreciated.
Dave