TemporalDistortion
Member
Hi all,
I'm back with another Allen bradly question!
This time even simpler then the last...
For some reason my coils are not going positive when I have a boolean go high
(as shown in the following picture)
https://imgur.com/a/ZyMRy
This is the only instance of the coil (so its not being set low elsewhere) and I've tried both a set and a regular coil.. but neither works
Is there some essential setting I'm forgetting somewhere?
The PLC is definitely in Run mode! I just cant figure out why my coils aren't going high!
I'm back with another Allen bradly question!
This time even simpler then the last...
For some reason my coils are not going positive when I have a boolean go high
(as shown in the following picture)
https://imgur.com/a/ZyMRy
This is the only instance of the coil (so its not being set low elsewhere) and I've tried both a set and a regular coil.. but neither works
Is there some essential setting I'm forgetting somewhere?
The PLC is definitely in Run mode! I just cant figure out why my coils aren't going high!