Handles101
Member
Hello Everyone,
I've got a bit of an ASCII problem with a device I'm trying to communicate to using a Micrologix 1500 controller. I could send a ascii command, but for some reason I cannot receive any ascii characters back. I used hyperterminal to verify my device is sending and receiving correctly. I wonder, does it have to do with the termination characters in my plc? There is something my in ascii configuration that is not correct, pls. help me solve this problem. Thanks in advance.
Fred
I've got a bit of an ASCII problem with a device I'm trying to communicate to using a Micrologix 1500 controller. I could send a ascii command, but for some reason I cannot receive any ascii characters back. I used hyperterminal to verify my device is sending and receiving correctly. I wonder, does it have to do with the termination characters in my plc? There is something my in ascii configuration that is not correct, pls. help me solve this problem. Thanks in advance.
Fred