gbradley
Lifetime Supporting Member
I have a micrologix 1000 controller that occasionally faults out.
I get a Fatal Internal Hardware Error occured S:1/13 also S:5/8
When I clear the Major error it puts a 0 into S:1/13, but if I try and go back into run mode, it Faults immediately.
If I clear both S:1/13 and S:5/8 to 0 it Runs fine, but after a day, or an hour, or 15 minutes??? it faults out again.
I'll probably just change out the controller, but I was wondering if anybody has seen this error before.
Thanks
George Bradley
I get a Fatal Internal Hardware Error occured S:1/13 also S:5/8
When I clear the Major error it puts a 0 into S:1/13, but if I try and go back into run mode, it Faults immediately.
If I clear both S:1/13 and S:5/8 to 0 it Runs fine, but after a day, or an hour, or 15 minutes??? it faults out again.
I'll probably just change out the controller, but I was wondering if anybody has seen this error before.
Thanks
George Bradley