Vincentlwg55
Member
Hi, i got a question . I'm using Mitsubishi PLC, CPU is Q25H. I would like to know the following command means [ENC0 F0 D12345 ...]
Mitsubishi PLC
- Thread starter Vincentlwg55
- Start date
[ENC0 F0 D12345 ...] this is only part of the function should be [ENCO M10 D8 K3] this decodes the 8 bits from M10 (to M17) & gives a decimal value in D8
i.e. if M13 is on then this being bit 3 (M10 being bit 0) then D8 will have a value of 3 M18 will give a result of 4 etc.
the manual is here:
http://www.mitsubishi-automation.co.uk/
This function basically checks a bit on in a range
i.e. if M13 is on then this being bit 3 (M10 being bit 0) then D8 will have a value of 3 M18 will give a result of 4 etc.
the manual is here:
http://www.mitsubishi-automation.co.uk/
This function basically checks a bit on in a range
Similar Topics
Hi,
How to get data from multiple Mitsubishi Q03UDVCPU into master PLC Q03UDVCPU through QJ71E71-100 ?
Hello,
I have a Mitsubishi FX3G 14M PLC and a E615 HMI from Mitsubishi/Beijer.
I'm using GXWorks 2 to do the programming and I have no problem...
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
Hi , Where i can find Mitsubishi PLC Card end of line & replacement model details. i am looking for Q02CPU replacement model. Please advice. thanks
I have Toyopuc PLC PC10G-CPU and some communication modules of it. With this modules I'm able to connect with Ethernet, Ethernet/IP, FLnet, FRMT...