Mas01
Member
Hi,
Correction: title should say GTDesigner3 (not softGOT)
I've updated some GUI pages using GT designer3 and I'm at the point where I want to "link" it (for want of a better term) to the software in the PLC. The PLC code itself is unchanged, it's only the PC-based GUI that I've updated with new display parameters.
Does anyone know how I can get my pages to connect to the PLC?
Part of the problem is that when I run SoftGOT1000, it immediately connects to the PLC, but these GUIs are the original ones - not the ones that include my updates.
Hopefully, getting the PLC to "link" to my GUI pages is not too difficult!
Thanks
Correction: title should say GTDesigner3 (not softGOT)
I've updated some GUI pages using GT designer3 and I'm at the point where I want to "link" it (for want of a better term) to the software in the PLC. The PLC code itself is unchanged, it's only the PC-based GUI that I've updated with new display parameters.
Does anyone know how I can get my pages to connect to the PLC?
Part of the problem is that when I run SoftGOT1000, it immediately connects to the PLC, but these GUIs are the original ones - not the ones that include my updates.
Hopefully, getting the PLC to "link" to my GUI pages is not too difficult!
Thanks
Last edited: