Mitsubishi R08SFCPU and RD78G8 communication to FR-E800SCE (Safety Version) on CC-link IE TSN

[cottagewood]

I'm struggling to get an FR-E800SCE to work on CC-Link IE TSN. I'm sure the issue is with the drive, when I plug in the network cable I get no link light on the port. I can plug my laptop in with FR-Configurator and the port works fine, it just isn't being recognised as CC-Link TSN from the RD78G8.
I set the parameters P1427-30 to 45238 and I tried every setting in P544 (CC-Link Extended setting) and S02 to 1 (Safety enable). Every time I make a change I power cycle the PLC and drive but I'm getting nowhere.

I have a servo drives and remote IO modules on CC-Link and the port link light works fine, even if there is nothing configured for them in the PLC

 

[cottagewood]

It was com speed, the default for the RD78G8 card and the servo drives is 1GB and the FR-E800SCE inverters can only do 100mb