TheWaterboy
Lifetime Supporting Member + Moderator
First time trying this particular combo. ML1400 and PLC5 over radio.
Initially I used 2 PLC5's and set them up to talk across the radio link and that worked just fine. So that clears the radio config from the equation
I set up MSG in the ML1400
This Controller:
Channel 2
PLC5 Read
N7:100
10 elements
Target Device:
timeout 5
N7:200
Node addr 35 (dec)
Local
2 errors depending on Channel protocol selection
Channel 2 set for DF1 Radio Modem:
Errors with message timed out in local processor
Channel 2 set for DF1 Full Duplex:
Error Hex 7 Target Node does not respond DF1 DLE Ack/NAK timeout . . .
ON difference I can see from the PLC5 and the ML1400 are
Channel in PLC5 is System Point to Point
There is no "typed" read in the ML1400
what am I not getting right here? Is DF1 Full Duplex right when radio is Simplex? (one freq for TX and RX)
Initially I used 2 PLC5's and set them up to talk across the radio link and that worked just fine. So that clears the radio config from the equation
I set up MSG in the ML1400
This Controller:
Channel 2
PLC5 Read
N7:100
10 elements
Target Device:
timeout 5
N7:200
Node addr 35 (dec)
Local
2 errors depending on Channel protocol selection
Channel 2 set for DF1 Radio Modem:
Errors with message timed out in local processor
Channel 2 set for DF1 Full Duplex:
Error Hex 7 Target Node does not respond DF1 DLE Ack/NAK timeout . . .
ON difference I can see from the PLC5 and the ML1400 are
Channel in PLC5 is System Point to Point
There is no "typed" read in the ML1400
what am I not getting right here? Is DF1 Full Duplex right when radio is Simplex? (one freq for TX and RX)