AutomationTechBrian
Lifetime Supporting Member
A customer asked if I could change an output address in a SLC 500 that he thinks is bad. I've not worked with that PLC before, so I asked him to send a picture of the programming port and any cables they might have. I'm scheduled to go there this morning, and he's an hour away, so I need to make sure I'm able to work with it. The first question... Does Logix 500 work with it? It just occurred to me it might be before that time. If Logix 500 works, are there any "gotchas" I should know about.
I'll do some searching, but since my time is short I wanted to throw this up first and see what comes of it.
I'll do some searching, but since my time is short I wanted to throw this up first and see what comes of it.