Unregistered
Guest
U
I have an application that I would like to add to an existing program. We are presently using a High Speed Counter (Using the A-B 1746-HSCE) to control a VFD star/stop. The HSCE is using an encoder for the feedback and the rate is approximately 260 ft/min of travel time. The length of travel is about 10 feet between cycles (15 sec per/cycle). During this travel cycle I would like to detect if the motion (Speed) has slowed down or completely stop before the register preset valve has been made.
Is there an output from the HSCE that I could use and do I have to configure the HSCE for rate mode? I would use the output to stop the VFD before any damage to the drive or our product.
Is there an output from the HSCE that I could use and do I have to configure the HSCE for rate mode? I would use the output to stop the VFD before any damage to the drive or our product.