Need help S7 comm with MM440 & Simored DC Master

keahock

Member
K
Join Date
Nov 2005
Location
Kuala Lumpur
Posts
9
hello,recently I have 1 project that use S7-315-2DP & profibus link to MM440 invertr & Simoreg DC master drive,but until now I just can up to the receive & transfer data between OB1 & DB,so how I know which address or parameter I read from drive & write to drive by just the DB1.xxx?Even I have read thru the manual but still confusing,can anyone help to describe more detail?
my config just to send command to start & send the speed reference,& from drive just read speed feedback,current feedback & fault signal only,or anyone have any example program I can refer to?
TQ!Please help !
 

Similar Topics

S
Need help with direct comm with a Ormec G series ServoDrive via DOS
This is an older system. My supervisor managed to let the magic smoke out of two of the comm boards in the ServoDrive controller, after replacing...
Replies
1
Views
1,337
Stig
S
C
Badly need help Modem-to-PLC comm
Hi everyone. I badly need help on this one. I am not able to receive SMS with a GSM modem directly hooked up to an SCU21 v1 of Omron CJ1M PLC...
Replies
0
Views
1,183
chikka_gurl143
C
K
Need Help Modifying Citect Scada Historical Trend Variable Data
So i've been at this for a long while, i have Citect Scada 2018, i have full access to everything but i can't seem to find any option or...
Replies
0
Views
54
kreamsippycup
K
D
I need help to make a Working Schedule for Make-up Air unit
I'm fairly new to Rockwell software, I've had some basic training in the past but nothing too advanced. My company and I use Reliable products for...
Replies
11
Views
348
drbitboy
drbitboy
C
Need Help Accessing/Printing a Program - CIMPLICITY
Hi all, I am having issues accessing my Cimplicity software - the site code changed after re-install and I am no longer able to attain a new key...
Replies
10
Views
174
Steve Bailey
Steve Bailey
Back
Top Bottom