Hello: I have a new out of the box Versa View 1250H terminal. I am trying to connect this to a DH485 network and SLC 5/03. In RSLInx I can see my laptop and SLC but not the Versa View terminal.
On the terminal when I select terminal Settings | Networks and Communications | RSLinx enterprise communications I see Virtual backplane, Ethernet, and Serial-DF1. However, all of these show <No Devices>. Hence I am unable to configure the node number of the terminal as described in the manual. I have cabled the terminal to my SLC network via the DH485 connector.
I also have a Panel View 600 that exhibits the same problem so I suppose I am doing the same thing wrong there as well.
Any ideas?
Thanks.
On the terminal when I select terminal Settings | Networks and Communications | RSLinx enterprise communications I see Virtual backplane, Ethernet, and Serial-DF1. However, all of these show <No Devices>. Hence I am unable to configure the node number of the terminal as described in the manual. I have cabled the terminal to my SLC network via the DH485 connector.
I also have a Panel View 600 that exhibits the same problem so I suppose I am doing the same thing wrong there as well.
Any ideas?
Thanks.