richard-jb
Member
Hello all and thanks for looking at this post.
I'm having trouble with an Omron CJ1W-MAD42 4 input 2 output analogue unit. I have set up the unit using CX prog and enabled output 1 (DM2000 bit 1). Other settings are 0-10v as output - otherwise standard settings. If I measure the voltage, I get -0.48v across the terminals (B1,B2). If i change the setting in CIO2001, then the voltage does not change at all, but if I exceed 4096 in CIO2001, the unit gives an error suggesting that it is accepting the value, but the voltage always reads -0.48. I have used Omron analogue units before (CQM1-MAD42's) and never had this problem. Does anyone have any good ideas?
Thanks
Richard
I'm having trouble with an Omron CJ1W-MAD42 4 input 2 output analogue unit. I have set up the unit using CX prog and enabled output 1 (DM2000 bit 1). Other settings are 0-10v as output - otherwise standard settings. If I measure the voltage, I get -0.48v across the terminals (B1,B2). If i change the setting in CIO2001, then the voltage does not change at all, but if I exceed 4096 in CIO2001, the unit gives an error suggesting that it is accepting the value, but the voltage always reads -0.48. I have used Omron analogue units before (CQM1-MAD42's) and never had this problem. Does anyone have any good ideas?
Thanks
Richard