Hi all,
First time posting here. I have a Omron NX1P2-1040DT controller that I intend to use for a small project. I also have a KUKA robot that has Beckhoff EK1100 Ethernet coupler with a bunch of cards attached to it. I would like to connect the Omron plc to the KUKA using EtherCat protocol.
When I try to connect an Ethernet cable from Omron Port 2 to EK1100 second port, red led turn on at "Net Err" on omron plc. Since both has EtherCat, I assume that we do not need to configure anything but error appear.
May I know how to communicate Omron PLC to the KUKA?
Beckhoff:
Ethernet coupler: EK1100
EL1809
EL2809
EL2622
EL9100
Thanks in advance for any assistance that can be provided (apologies if this question has already been posted).
First time posting here. I have a Omron NX1P2-1040DT controller that I intend to use for a small project. I also have a KUKA robot that has Beckhoff EK1100 Ethernet coupler with a bunch of cards attached to it. I would like to connect the Omron plc to the KUKA using EtherCat protocol.
When I try to connect an Ethernet cable from Omron Port 2 to EK1100 second port, red led turn on at "Net Err" on omron plc. Since both has EtherCat, I assume that we do not need to configure anything but error appear.
May I know how to communicate Omron PLC to the KUKA?
Beckhoff:
Ethernet coupler: EK1100
EL1809
EL2809
EL2622
EL9100
Thanks in advance for any assistance that can be provided (apologies if this question has already been posted).