Hallo to everyone.
I have an OMRON C28H plc with a monitor ( you can see attached foto) which is from an old marble polishing machine.
I do not know how this monitor works. Is there any information about this. The monitor refers that 'NINI TERM40D/S'.
Besides, i connect with plc and i uploaded the ladder diagram. I try to find out how the high speed counter works. The high speed counter counts the pulses at 000.00 input (present value) but i do not know where the set value is stored. I red the operation manual of the plc but it refers nowhere where you can store the set value which the high speed counter will compare with present value.
It has the below HDM instruction but i cant understant what this means
Operation manual refers that DM0110 is beginning table word and 040 is beginning result word.
I have found out that DM0905 which is for high speed counter settings has the value C000 (1100000000000000 bin) which means that bit 15 is for enable High speed counter and bit 14 is for reset HSC.
I would appreciate if anybody has any advice about stored set value and explain better about HDM instruction.
I have an OMRON C28H plc with a monitor ( you can see attached foto) which is from an old marble polishing machine.
I do not know how this monitor works. Is there any information about this. The monitor refers that 'NINI TERM40D/S'.
Besides, i connect with plc and i uploaded the ladder diagram. I try to find out how the high speed counter works. The high speed counter counts the pulses at 000.00 input (present value) but i do not know where the set value is stored. I red the operation manual of the plc but it refers nowhere where you can store the set value which the high speed counter will compare with present value.
It has the below HDM instruction but i cant understant what this means
Operation manual refers that DM0110 is beginning table word and 040 is beginning result word.
I have found out that DM0905 which is for high speed counter settings has the value C000 (1100000000000000 bin) which means that bit 15 is for enable High speed counter and bit 14 is for reset HSC.
I would appreciate if anybody has any advice about stored set value and explain better about HDM instruction.