NetNathan
Lifetime Supporting Member
I just recently started using Aegis shaft grounding units on my motors due to a rash bearing failures.
OT: VFD induced shaft currents. What's the solution?
- Thread starter lesmar96
- Start date
Similar Topics
Application:
I have two pumps, a 20 Hp and a 10Hp 3/ph 460v in the same conduit.
The Vfd's are located in each mcc bucket.
I have been getting...
Otis and Bubba just pulled a three year old 40 HP motor from service that has some apparent bearing problems at one particular part of its...
I have a cell with a compact guardlogix as the plc and I have three hmi's and two vfd's on this cell. I been experiencing momentary comms faults...
So i need to communicate my VFD (LS Electric iS7) with XGL PMEB module i successfully set the gsd file now i cant figure out how the data works...
Hi,
I need to replace damage control board of 37kw Danfoss fc360, I have a control board of 30kw of same Model FC360, how to change that board...