forqnc
Lifetime Supporting Member
Hi, I'm working a project, I set up some recipes to be stored on the USB on a panelview plus (2711TP-T7C21D8S). This is working fine, expect when the panelview is rebooted, it does not see the USB drive. I have to unplug it and re-plug it in.
Working further on the project (data logging) again it does not see the USB after a power up/re-boot.
I'm really hoping there is something I am missing, since it seems needing to open a panel to Reset the drive, every power up, is ludicrous.
This is my first project on a panelview, so I am really hoping I am missing the obvious.
Working further on the project (data logging) again it does not see the USB after a power up/re-boot.
I'm really hoping there is something I am missing, since it seems needing to open a panel to Reset the drive, every power up, is ludicrous.
This is my first project on a panelview, so I am really hoping I am missing the obvious.