danny.michael
Lifetime Supporting Member
I'm starting up a new system at a customer site this week. The control panel has a PanelView Plus 1250 with DH+ communications adapter installed. At the end of the day today, I powered the PanelView up and planned to set the DH+ address before the electricians connect it to the network tomorrow morning. I expected the DH+ adapter to show up in the communications tree, but it wasn't there. Just the virtual backplane, Ethernet, and DF1 adapters. All of the LED indicators on the DH+ card are off.
Do I have to do anything special to get the DH+ adapter to show up in the configuration? The manual doesn't mention anything special, and I've spent an hour on the knowledgebase with no luck. I've configured a lot of Ethernet PanelViews, but this is my first on DH+.
Thanks,
Danny
Do I have to do anything special to get the DH+ adapter to show up in the configuration? The manual doesn't mention anything special, and I've spent an hour on the knowledgebase with no luck. I've configured a lot of Ethernet PanelViews, but this is my first on DH+.
Thanks,
Danny