phuz
Member
I think we have an issue on an air conveying table where the downstream blower is "pulling" the upstream blower slightly faster causing an overvoltage.
Is there a parameter that would help alleviate this?
I was told it was happening while they were running, but I have to wonder if it truly happened during a decel. Just for the heck of it, I increased the decel from 10 sec to 12 sec.
Is there a parameter that would help alleviate this?
I was told it was happening while they were running, but I have to wonder if it truly happened during a decel. Just for the heck of it, I increased the decel from 10 sec to 12 sec.
Last edited: