Good Afternoon ,
I'm sorry , but here is another one. I have the PowerFlex 525 speed reference set to Ethernet / IP and it is running at 60 HZ . The PLC is telling
it to run 0 HZ , but it still wants to run at 60 HZ. The b002 ( Commanded Freq ) is saying 60.0 HZ . I have all the speed references set to 15 ( EtherNet / IP ) . I change it to 1 ( Drive Pot ) and it goes down to 0 and then I can control the speed with the pot. Ethernet is telling it to run that speed .
Have you guys seen this before ? It blows my mind .
Thanks for your help again.
I'm sorry , but here is another one. I have the PowerFlex 525 speed reference set to Ethernet / IP and it is running at 60 HZ . The PLC is telling
it to run 0 HZ , but it still wants to run at 60 HZ. The b002 ( Commanded Freq ) is saying 60.0 HZ . I have all the speed references set to 15 ( EtherNet / IP ) . I change it to 1 ( Drive Pot ) and it goes down to 0 and then I can control the speed with the pot. Ethernet is telling it to run that speed .
Have you guys seen this before ? It blows my mind .
Thanks for your help again.