cardosocea
Member
Hello,
I'm setting up an application where I'll have a couple of Powerflex drives commanded from a PLC on a network.
However, we want to be able to run the drives manually in the event of a PLC failure and I was asked to leave some hardware buttons and a switch to swap over the command source between the PLC and buttons.
I've read the manual a few times and it's really not clear how to do this in the setup. Has anyone ever done this?
I'm setting up an application where I'll have a couple of Powerflex drives commanded from a PLC on a network.
However, we want to be able to run the drives manually in the event of a PLC failure and I was asked to leave some hardware buttons and a switch to swap over the command source between the PLC and buttons.
I've read the manual a few times and it's really not clear how to do this in the setup. Has anyone ever done this?
Last edited: