Hans Sietsema
Member
Hello,
I've got a problem with a system running IFix 3.5.
It's a ship with two Fanuc 90-30 PLC's and with 2 HMI (desktop computers)
Both computers failed and I got the data from one conputer back.
Now got both computers up and rnning again but I can't run them together.
Since the software Windows XP isn't supported anymore I made a Virtual machine that is running on Windows 10.
This works great and if one system is running the communication is OK.
As soon as I start the second computer the communication fails and ? are shown in the graphics.
I can see on the driver that with one computer there is no stack overflow and errors but with the second machine running these counters go up fast.
I can't find the place where I can indicate there are 2 HMI's or set anything so both computers can run together.
The network is setup correctly and the computernames are unique.
Has anyone got any experiance with this????
Regards,
Hans Sietsema
I've got a problem with a system running IFix 3.5.
It's a ship with two Fanuc 90-30 PLC's and with 2 HMI (desktop computers)
Both computers failed and I got the data from one conputer back.
Now got both computers up and rnning again but I can't run them together.
Since the software Windows XP isn't supported anymore I made a Virtual machine that is running on Windows 10.
This works great and if one system is running the communication is OK.
As soon as I start the second computer the communication fails and ? are shown in the graphics.
I can see on the driver that with one computer there is no stack overflow and errors but with the second machine running these counters go up fast.
I can't find the place where I can indicate there are 2 HMI's or set anything so both computers can run together.
The network is setup correctly and the computernames are unique.
Has anyone got any experiance with this????
Regards,
Hans Sietsema