er1k
Member
Hi@all!
I need some help concerning a Crouzet Millenium 3.
I want to build a control system for 3 hydraulic pump stations.
The outputs of the Crouzet PLC are the inputs of the PLC of the pump stations. I am not sure if this works because of the minimum load of the PLCs outputs. Can I just add a parallel resistor to reach the minimum current? Is it correct to use relay outputs for that?
I am also not sure if there will be some troubles because of the different grounds?
Erik
I need some help concerning a Crouzet Millenium 3.
I want to build a control system for 3 hydraulic pump stations.
The outputs of the Crouzet PLC are the inputs of the PLC of the pump stations. I am not sure if this works because of the minimum load of the PLCs outputs. Can I just add a parallel resistor to reach the minimum current? Is it correct to use relay outputs for that?
I am also not sure if there will be some troubles because of the different grounds?
Erik