Hi,
I am connecting an Autonics make stepper driver type, MD5-ND14 to a Kinco PLC (K205 series) this has a sourcing output which cannot be changed to sinking.
I have tried out two different types of connections, common positive & common negative. The circuits are attached. Only the common negative works.
Could anyone explain why? I would prefer the common positive option. Any way this can be realized?
Link to MD5-ND14 datasheet
https://www.dropbox.com/s/6yvh4z2hsvnaedy/MD5-ND14.pdf?dl=0
Link to Kinco K2 datasheet
https://www.dropbox.com/s/381eokibm3ku39l/L011558 - Kinco K205E PLC Spec Sheet.pdf?dl=0
Thanks
a
I am connecting an Autonics make stepper driver type, MD5-ND14 to a Kinco PLC (K205 series) this has a sourcing output which cannot be changed to sinking.
I have tried out two different types of connections, common positive & common negative. The circuits are attached. Only the common negative works.
Could anyone explain why? I would prefer the common positive option. Any way this can be realized?
Link to MD5-ND14 datasheet
https://www.dropbox.com/s/6yvh4z2hsvnaedy/MD5-ND14.pdf?dl=0
Link to Kinco K2 datasheet
https://www.dropbox.com/s/381eokibm3ku39l/L011558 - Kinco K205E PLC Spec Sheet.pdf?dl=0
Thanks
a
Last edited: