Redundancy???
- Thread starter ramyau
- Start date
Soumya,
1. Turn off power for the redundant CPU.
2. Connect the RS232 cable to the COM port on the CPU.
3. Turn the power back on.
4. Configure the communications parameters for the COM port so that it matches your RS232 device.
1. Turn off power for the redundant CPU.
2. Connect the RS232 cable to the COM port on the CPU.
3. Turn the power back on.
4. Configure the communications parameters for the COM port so that it matches your RS232 device.
Amr Hassan
Member
- Join Date
- May 2005
- Posts
- 340
what is babcock
Similar Topics
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Hello,
My associate and I are trying to sync up two ControlLogix racks (7-slot chassis) with identical modules. We are able to see the secondary...
Hello, I have a ControlLogix redundant controller being set up. The program reads a value from a remote site which hosts a SLC PLC. Rockwell...
Guys, please help me with this urgently.
We have Logic 5575 installed in hot n standby setup. For some reason, the primary now cannot sync with...
Hi Guys,
Is it okay to have Redundancy ControlLogix Processor IP address set to DHCP?
I had Static IP address on it but removed it via RSLinx...