Hi again,
I finally got back to my RIO problems I've been having. I worked out the programming bugs that I could find and got my discrete I/O working. Kinda, I still have 3 outputs changing states but RSLogix doesnt show the outputs being on. These outputs are not being used in the program but will change its physical states when my BTR and BTW change states (from EN to ER)and then gives a error. Not sure why this is happening and was wondering if anyone evr seen this problem before?
One other problem I see is the BTR never sets the DN bit just the er bit.
I was reading up on the .RLEN and the .DLEN and seen that the .DLEN has to equal the .RLEN or it will give a error. But this value changes from 0 to 8.(This is with a working BTR/BTW instruction on a different panel used as a reference) Why does it change? Not sure whts happening here, any ideas?
I finally got back to my RIO problems I've been having. I worked out the programming bugs that I could find and got my discrete I/O working. Kinda, I still have 3 outputs changing states but RSLogix doesnt show the outputs being on. These outputs are not being used in the program but will change its physical states when my BTR and BTW change states (from EN to ER)and then gives a error. Not sure why this is happening and was wondering if anyone evr seen this problem before?
One other problem I see is the BTR never sets the DN bit just the er bit.
I was reading up on the .RLEN and the .DLEN and seen that the .DLEN has to equal the .RLEN or it will give a error. But this value changes from 0 to 8.(This is with a working BTR/BTW instruction on a different panel used as a reference) Why does it change? Not sure whts happening here, any ideas?