ubay
Guest
U
i am new in using PLC. Our university have SLC-500 with RSLogix 500 as the Ladder programing languange and RSLinx Lite which came with the RSLogix 500.
first time i use it, there's nothing wrong with the PLC.
but later on, in the RSLinx showed red sign then i remove it as it told in the help files... so the devices is gone..
but after that i can't communicate with the SLC500...
btw. i communicate with RS232
i try so many ways.. using Ethernet but it's still can't came up with anything..
i also had done configure drivers, and drivers doagnostic ... and i got that there's communication ---> seen from packets sent and reply but i still can't detect my PLC...
is there anybody know hoe to fix this problems ??
i need it as soon as possible... please...
now i'm in desperate condition...
help me pleaaaseeee.....
thenk you for all the advise..
mail me at : [email protected] or [email protected]
first time i use it, there's nothing wrong with the PLC.
but later on, in the RSLinx showed red sign then i remove it as it told in the help files... so the devices is gone..
but after that i can't communicate with the SLC500...
btw. i communicate with RS232
i try so many ways.. using Ethernet but it's still can't came up with anything..
i also had done configure drivers, and drivers doagnostic ... and i got that there's communication ---> seen from packets sent and reply but i still can't detect my PLC...
is there anybody know hoe to fix this problems ??
i need it as soon as possible... please...
now i'm in desperate condition...
help me pleaaaseeee.....
thenk you for all the advise..
mail me at : [email protected] or [email protected]