RSView Studio SE Alarm Summary

[awnet]

Hi All!

Can you help with this problem? I have used the alarm summary in a project made with RSView Studio SE, but I haven't been able to link this to the alarms that I have defined in the HMI TAGS. This should be quite simple, in fact I have to specified the path when you click on the button "Data" of the menu bar of the RSView, however I haven't understood.

Thank You very much!
Bye
Michele

 

[Mark Buskell]

When you set up yout tags, did you click on the little checkbox that set them as an alarm in the lower right corner?