Hi there. Looking for a way in RSView Studio ME to indicate that there is an alarm active (unacked) in the system, without having to use the default method of splashing a alarm banner on the screen. Essentially, just to be able to have a HMI bit tag that is high if one or more alarms are active in the system, or low if there are no active alarms.
I would then use this tag to produce a flashing indication in the top banner, which would then allow the operator to open the alarm screen at his/her discretion.
Any ideas?
I would then use this tag to produce a flashing indication in the top banner, which would then allow the operator to open the alarm screen at his/her discretion.
Any ideas?