Barry Kirk
Lifetime Supporting Member
I was recently given a new PC at work that supposedly has RSView Studio pre-installed on it.
When I go to start RSView Studio it comes up with a screen that says Product Type Selection and then it says Select the type of product that you would like to configure.
The selection dialog for Product type selection is empty and at the bottom are two buttons continue and exit with continue ghosted out.
I suppose if I were able to select one of the nonexistent product types it would unghost the continue button.
How do I proceed to get RSView running.
I'm trying to program a Panelview Plus 600
When I go to start RSView Studio it comes up with a screen that says Product Type Selection and then it says Select the type of product that you would like to configure.
The selection dialog for Product type selection is empty and at the bottom are two buttons continue and exit with continue ghosted out.
I suppose if I were able to select one of the nonexistent product types it would unghost the continue button.
How do I proceed to get RSView running.
I'm trying to program a Panelview Plus 600