s5 cp problem

notfish

Member
N
Join Date
Apr 2003
Posts
15
i have a s5 cp connected to sinec l2 net,but recently the cp always on the stop mode,the run led only light on while starting up lasting for few seconds.i had replaced the cp with another one which had been tested ok,but the problem remain.

can somebody help me?THX!
 
notfish

I have very little experience with S5 cp cards, but I do know that the card needs to be syncronised with the PLC, sorry I can't remember what FB does this, I think its called SYNCRON,

I am sorry I can't help you further, give the Siemens support web site a try

Paul
 

Similar Topics

C
Can you help me with this problem? (Fibonacci sequence in tia portal)
Hello, I need to write the following program in Ladder language, but I could not integrate the Fibonacci sequence into the ladder. Can you help...
2
Replies
22
Views
464
JesperMP
JesperMP
H
problem in Eplan P8
On all pages of my project i have a lot of information, texts and details that should not not be shown. I can remove them for each part apart from...
Replies
0
Views
53
Haytham_93
H
R
TIA portal, problem upgrade project to newer version
Hi, I have had problem with upgrading some projects from v16 to v18. I tried it on 3 diffrent computers. I want to post this so that anyone that...
Replies
3
Views
215
rQx
R
M
ACS355-03E-44A0-4 Installation Problem
Hi, I am having a challenge installing a new drive ACS355-03E-44A0-4 as it keeps on displaying Fault code F00018 even when the load is not...
Replies
3
Views
153
BryanG
B
B
Fatek WinProLadder communication problem
I have an issue on my vessel, we have water tight door system created in China, company is no longer operating. We have 7 doors each with their...
Replies
4
Views
167
Burnavator
B
Back
Top Bottom