Hi Guys
I've been given a code that I have to use to simulate a process. Unfortunately it causes the Unity pro inbuilt simulator to go into halt mode. Sometimes it happens as soon as I start the simulator, other times it halts after few seconds.
Running: Unity Pro V7 on windows 7
Status bits:
%S18 is set (Arithmetic error).
%SW125 is 16#DEF2 (Arithmetic error).
%SW126 (ERROR ADDRESS 0) is 16#B9BC.
%SW127 (ERROR ADDRESS 1) is also 16#773D.
The manual says the last two words should contain the instruction address. However I've no idea how to locate a particular instruction using this kind of address.
Many thanks for your help.
Regards,
Moeen.
I've been given a code that I have to use to simulate a process. Unfortunately it causes the Unity pro inbuilt simulator to go into halt mode. Sometimes it happens as soon as I start the simulator, other times it halts after few seconds.
Running: Unity Pro V7 on windows 7
Status bits:
%S18 is set (Arithmetic error).
%SW125 is 16#DEF2 (Arithmetic error).
%SW126 (ERROR ADDRESS 0) is 16#B9BC.
%SW127 (ERROR ADDRESS 1) is also 16#773D.
The manual says the last two words should contain the instruction address. However I've no idea how to locate a particular instruction using this kind of address.
Many thanks for your help.
Regards,
Moeen.
Last edited: