Hi,
I'm trying to set up a CP 343 - 1 and think I'm struggling at the set up of the CP 343-1 part. In FC40 and FC41 I'm trying to set the "logic module address of cp". I'm assuming this is 256 which is what I have on the cp's hardware config. If I've put 100 as the HEX value like in the pic.
Trouble is, when I download it, the CP starts flashing SF, BF, Stop and Run.
When I change the address to W#16#1000 the CP is ok, but the CPU stops and has a system fault.
Do I have the correct CP address. Or am I trying to send too much data? Or something else?
Many thanks
I'm trying to set up a CP 343 - 1 and think I'm struggling at the set up of the CP 343-1 part. In FC40 and FC41 I'm trying to set the "logic module address of cp". I'm assuming this is 256 which is what I have on the cp's hardware config. If I've put 100 as the HEX value like in the pic.
Trouble is, when I download it, the CP starts flashing SF, BF, Stop and Run.
When I change the address to W#16#1000 the CP is ok, but the CPU stops and has a system fault.
Do I have the correct CP address. Or am I trying to send too much data? Or something else?
Many thanks