Ones_Zeros
Member
Hello
I was needing some guidance on communicating and setting up a totalizer from a flow meter in the PLC.
The PLC is a AB 1769 Compact Logic controller
I’ve never setup a (TOT) Totalizer, but I’m currently communicating to
the Flow meter via 4-20ma out to the PLC input card.
- Do I have to import a new “Data Type” to communicate to the flow meter by Hart?
- Is the best way to setup a Totalizer function in the PLC is to communicate to the meter by Hart?
- Any guidance on setting up the communications & setting up the TOT totalizer would be greatly appreciated.
I attached the TOT instruction from the PLC
- what would need to be configured on this instruction?
- the flow meter is measuring water (Gal/min)
Thanks for helping
I was needing some guidance on communicating and setting up a totalizer from a flow meter in the PLC.
The PLC is a AB 1769 Compact Logic controller
I’ve never setup a (TOT) Totalizer, but I’m currently communicating to
the Flow meter via 4-20ma out to the PLC input card.
- Do I have to import a new “Data Type” to communicate to the flow meter by Hart?
- Is the best way to setup a Totalizer function in the PLC is to communicate to the meter by Hart?
- Any guidance on setting up the communications & setting up the TOT totalizer would be greatly appreciated.
I attached the TOT instruction from the PLC
- what would need to be configured on this instruction?
- the flow meter is measuring water (Gal/min)
Thanks for helping