MarkNightingale
Lifetime Supporting Member + Moderator
Hi,
Yesterday, I was at a customer site. I made one little change. Changed a dummy bool output to an actual output. I didn't add any tags, or any markers, just changed to an output that was already in the hardware configuration.
When I tried to download the change, I got a memory full error. I tried to compress the memory, as I have done in the past, but it would not load the block to the PLC.
Is there anything else I can try, before I tell the customer they need to upgrade the CPU.
Cheers
Mark
Yesterday, I was at a customer site. I made one little change. Changed a dummy bool output to an actual output. I didn't add any tags, or any markers, just changed to an output that was already in the hardware configuration.
When I tried to download the change, I got a memory full error. I tried to compress the memory, as I have done in the past, but it would not load the block to the PLC.
Is there anything else I can try, before I tell the customer they need to upgrade the CPU.
Cheers
Mark