I just had a vendor change his mind on the type of Siemens PLC he wanted to use from an S7-400 to an S7-300.
After printing all of the S7-400 books out and getting the drawings almost done I have to start over...I think...
The S7400 addressing stated that the addressing was obtained by taking the (slot number - 1) x 4. Fore example if I had a digital module in slot 5 that would be (5 -1) x 4 = I16.0 - I16.7 for the address.
Does this also apply for the S7300 or is it different....Until I can get a manual printed anyone know?
After printing all of the S7-400 books out and getting the drawings almost done I have to start over...I think...
The S7400 addressing stated that the addressing was obtained by taking the (slot number - 1) x 4. Fore example if I had a digital module in slot 5 that would be (5 -1) x 4 = I16.0 - I16.7 for the address.
Does this also apply for the S7300 or is it different....Until I can get a manual printed anyone know?