jihadabuhoran
Member
Dears
i have a Simatic OP 27 connecetd over the Profibus to S7 315-2DP CPU PLC, i have the following problim:
after downloading all the software configuration to the both PLC and the OP 27, and connect the ProfiBus, the OP 27 start-up and it will give a message # 339 (Startup Compleated) and it will not reset or Ach
knoldge the error message.
i tried to repeate the same but same message keeps ON, i have advised the client to replace the same OP, sice i think there is a damage in the OP,
Please advice on urgent, is there any posible to put the OP on order
Regards
Jihad
i have a Simatic OP 27 connecetd over the Profibus to S7 315-2DP CPU PLC, i have the following problim:
after downloading all the software configuration to the both PLC and the OP 27, and connect the ProfiBus, the OP 27 start-up and it will give a message # 339 (Startup Compleated) and it will not reset or Ach
knoldge the error message.
i tried to repeate the same but same message keeps ON, i have advised the client to replace the same OP, sice i think there is a damage in the OP,
Please advice on urgent, is there any posible to put the OP on order
Regards
Jihad