plcengineer
Member
I have a new system that I am working on.. It consists of a CU-320-2 DP, AIM, ALM and three motor modules... The three motor modules will be designated as one master and two slaves.. We will set the speed for the master from the plc via profibus, then we need to send dynamic ratios to the slaves.. For example, we will set M1 Speed, then we will adjust the ratio-speed of S1 Vs M1 and we will adjust ratio-speed of S2 Vs M1..
Do I need a CBE20 card in my CU-320-2 DP or can I just plug drives in CLIQ?
Does anyone have any information that would be helpful with me to start getting this setup.. I am a newbie to the Sinamics Platform..
I would like some assistance on how to setup the master-slave system that I am referring to..
Thanks,
Do I need a CBE20 card in my CU-320-2 DP or can I just plug drives in CLIQ?
Does anyone have any information that would be helpful with me to start getting this setup.. I am a newbie to the Sinamics Platform..
I would like some assistance on how to setup the master-slave system that I am referring to..
Thanks,