Hi first time today logging onto slc 500 5/03. Must say found it quite a challenge. Basically the machine has a rotating table which carries out various functions as it rotates. On one section a cylinder drops down onto a part and carries out a continuity test through a component. If the plc detects a fail then a reset button must be pushed (I:1/11) and the part removed manually. I have fitted a sensor today which drives I:4/11. Reason: If the operator pushes the reset button and does not remove the part then the machine will continue and the reject part will be placed in the non-reject bin. The sensor detects the part and I would like to incorporate this sensor into the reject rung. If the part is faulty then even if the reset push button is pressed then it will still see a fail as the input I:4/11 still see;s the reject part. Can anyone suggest how I can utilize this sensor into the programme.
I'm not looking for some one to carry out my work but I would like some good advise so I can learn quickly and resolve my problem.
Thanks.
I'm not looking for some one to carry out my work but I would like some good advise so I can learn quickly and resolve my problem.
Thanks.
Last edited: