I went to site today. I changed the plc battery and put it on back on.
Program seems to be in the plc and the run light is on and the dh45 and rs232 is green.
The channel o is connected to an hmi panelview 600.
I looked in the program offline and both channels are dh485 19200.
I tried to connect to this plc now but obviously because I'm using the rs232 df1 it wont allow me to see the plc.
Is there a way change the channels on the program and maybe make the channel 0 df1.
How would I then transfer the changed program to the plc.
Program seems to be in the plc and the run light is on and the dh45 and rs232 is green.
The channel o is connected to an hmi panelview 600.
I looked in the program offline and both channels are dh485 19200.
I tried to connect to this plc now but obviously because I'm using the rs232 df1 it wont allow me to see the plc.
Is there a way change the channels on the program and maybe make the channel 0 df1.
How would I then transfer the changed program to the plc.