mrtweaver
Member
Good afternoon, i have been reading some postings and wanted some clarification from some of the AB experts on this site.
First question, i take if from what i am reading that there is differences between 1746-HSCE and 1746-HSCE2 and that one is not an exact drop in for the other. Am i correct in understanding that?
Second I also take it the HSCE2 is probably the newer model since it has the number 2 after it?
Third, i have a 4 slot base, with 1747-L541 CPU and 1746-HSCE, am using RS Logix 500 v7. Have been trying to configure the unit so that i can use the outputs and also use the high speed quadrature encode in, but it does not like something, just not sure what, i am sure it has to do with configuration but being i have never configured one of these HSCE units before thought maybe someone can give some guidance on it.
When i went in i configured all my board, cpu is in slot 0, hsce is in slot 1, 16 point input module in slot 2 and analog output card in slot 3.
So I am wondering if my version of software being older is what is causing the issue of me not being able to get the unit properly working or what.
Any help or pointers greatly appreciated. And no my company does not have a support contract with AB, although i would like them to.
First question, i take if from what i am reading that there is differences between 1746-HSCE and 1746-HSCE2 and that one is not an exact drop in for the other. Am i correct in understanding that?
Second I also take it the HSCE2 is probably the newer model since it has the number 2 after it?
Third, i have a 4 slot base, with 1747-L541 CPU and 1746-HSCE, am using RS Logix 500 v7. Have been trying to configure the unit so that i can use the outputs and also use the high speed quadrature encode in, but it does not like something, just not sure what, i am sure it has to do with configuration but being i have never configured one of these HSCE units before thought maybe someone can give some guidance on it.
When i went in i configured all my board, cpu is in slot 0, hsce is in slot 1, 16 point input module in slot 2 and analog output card in slot 3.
So I am wondering if my version of software being older is what is causing the issue of me not being able to get the unit properly working or what.
Any help or pointers greatly appreciated. And no my company does not have a support contract with AB, although i would like them to.