PLC_SLC500
Member
Good Afternoon, First time poster, many week reader.
I am a hobbiest and have an SLC500 system working with RSLogix 500
I at the moment have a 7 slot chassis an IB16 and an OW16 module connected to a 5/04 CPU
the RSLogix software can see all modules correctly however anytime i try and add an output to the ladder logic and run it i get a Data Rack error
I have tried: -
the output module in other slots - same error.
the input module in the same slots as the output was removed from - works reading the input fine.
I have earthed the chassis.
have any of you seen this issue before?
thankyou
I am a hobbiest and have an SLC500 system working with RSLogix 500
I at the moment have a 7 slot chassis an IB16 and an OW16 module connected to a 5/04 CPU
the RSLogix software can see all modules correctly however anytime i try and add an output to the ladder logic and run it i get a Data Rack error
I have tried: -
the output module in other slots - same error.
the input module in the same slots as the output was removed from - works reading the input fine.
I have earthed the chassis.
have any of you seen this issue before?
thankyou