MajorFault
Member
Anyone out there using Delta RMC100 to interface MTS temposonics (linear position sensors) with SSI output to a ControlLogix processors?
I currently have 6 160" temposonics w/ SSI output going back to 2 seperate (3 channels each)AMCI Nexxus modules that convert the SSI signal to ControlNet. Which then goes to a CNB card in rack with processor. I have had a few problems with this application and am looking for something better.
Please let me know if anyone out there has any experience (good or bad) with either of these two interfaces.
I currently have 6 160" temposonics w/ SSI output going back to 2 seperate (3 channels each)AMCI Nexxus modules that convert the SSI signal to ControlNet. Which then goes to a CNB card in rack with processor. I have had a few problems with this application and am looking for something better.
Please let me know if anyone out there has any experience (good or bad) with either of these two interfaces.